The SE tubular handlebars high in 28.6 mm are approx. 40 mm higher than our SE standard handlebars low and move the grip ends approx. 60 mm closer to the rider thanks to a stronger crank. This ensures an upright and comfortable riding position.
The SE high tubular handlebars in 28.6 mm and 22 mm differ only in their thickness in the centre area. The seating position is the same and the respective handlebar fittings fit both versions.
- Outside diameter 22mm, inside 28.6mm
- Width 790mm
- Height 100mm
- Depth 170mm
- Inner diameter 14mm
- including ABE / TÜV certificate
- Suitable for BMW fittings
- Aluminium anodized
- Suitable for SE cast aluminium handlebar switches
Note on the ABE: The ABE of the handlebar does not apply to the models of the two-valve/K-model-series. In this case, the handlebars must be approved by a TÜV centre and the documents must be registered. With the ABE as a basis, this is usually possible without any problems. In this case, the ABE as such confirms the suitability of the component, the suitability for installation is then approved by the test engineer.
