Quickshifter push and pull sensor for Powercommander V or Blipper.
This Dynojet Quick Shifter Sensor allows together with a Powercommander V the upshifting under load (without pulling the clutch and without taking off the throttle) - no matter if the shift linkage is pushed or pulled!
It has two connectors to use it either as a push or pull sensor.
The adjustment of the switching scheme is only possible by changing the connection - a matter of seconds!
Of course it can also be used with our Ignition Quickshifters to interrupt the ignition!
-fast, safe upshifting
-setting the duration of the shift interruption
-setting of the minimum speed for the function as shift interruption
-easy installation in the existing shift linkage
-only 17 mm diameter and approx. 40 mm long (without thread)
-one M6 male and one M6 female thread each
-encapsulated stainless steel housing
The sensor is simply connected to the Powercommander V and installed in the standard shift linkage. In the Powercommander software it can be controlled and adjusted directly.
